|
| |
| |
|
| Handguard Installation Instructions
|
| |
-
Lightly Lubricate the o-ring and
bar insert. To much grease will
cause the bar insert
to spin. Before installing in pro-taper
style bars, remove the o-ring and
install the insert
to make sure that it fits all the
way in. If it fits easily, try
it with the o-ring on. The o-ring
is optional, it may have to be
removed on some bars.
- Install the bar insert by
pushing only on the allen bolt
with a 5mm allen wrench. If
you press on the bar insert cap,
you will not be able to push
it all the way in. This will
also damage the expansion piece.
- If installing with hand guards
follow the diagram below...
- Tighten allen bolt snug,
not too tight. Apply the grip
over the bar and Bar Insert on
the left side.
Slide the throttle tube over
the bar and Bar Insert on the
right side.
|
| |
| Removal Instructions
|
| |
- Loosen allen bolt and remove expansion piece. Reinstall the bolt and grab it with channel locks/pliers.
- Gently pull or pry on the Bar Insert out of the bar.
|
| |
 |
|
|
|
 |
| |
|
|
|
|
|
 |
|
 |
|
|
 |
|
|
| |
 |
| Call us at 562-601-8119 Ext 1# for technical support
and ordering assistance. |
|
|
|
 |
| |
 |
|
|
click to enlarge |
|
|
|
|
|
|
|
|
|
